Upgrade report (from 3.3 to 3.4e)

Installer Issues via Installer -- Not for global upgrades or upgrading individual packages -- ONLY ISSUES WITH INSTALLATION OF THE OS -- Can't get Sabayon installed, than post here, otherwise use correct forums

Moderator: Moderators

Upgrade report (from 3.3 to 3.4e)

Postby sjeter » Sun Aug 12, 2007 18:40

I ran the upgrade - not the complete rescue or sixth sense - started a little after 9 am - left the house a little before 3 pm and it was at 55%. Returned about 9:20 pm and it was at 70% - the operation was as follows:
100% (1/1) Removing from Disk: net-voip/wengophone-bin-2.0-r1


I waited about 40 minutes more, then gave up and did a hard reset, rebooted and started the upgrade again, the complete rescue. I skipped the bootloader part, which turned out to be a mistake.

The next morning it was complete, and I rebooted. I got a message something like 'Error 15 - file not found'. I started rescue part again with only the bootloader part, fixed that, then rebooted. The boot process got to about 25% and then the screen went black, like it does when it's going into power sleep mode - I hit the escape key and got the following messages:

[ 36.053048] Device driver usbdev4.2-ep81 lacks bus and class support for being resumed.
[ 36.330964] Device driver usbdev4.2-ep81 lacks bus and class support for being resumed.
[ 36.338403] Device driver usbdev4.2-ep81 lacks bus and class support for being resumed.
[ 36.609283] Device driver usbdev4.2-ep81 lacks bus and class support for being resumed.
[ 36.616380] Device driver usbdev4.2-ep81 lacks bus and class support for being resumed.
[ 36.626863] Device driver usbdev4.2-ep81 lacks bus and class support for being resumed.

Now what?
sjeter
Simple Hen
 
Posts: 50
Joined: Wed Mar 07, 2007 14:09
Location: Near Houston, TX

Postby wolfden » Sun Aug 12, 2007 21:51

fresh install and in 40 minutes have yourself a useable computer instead of 3 days later and still not working.
wolfden
Sharecropper
 
Posts: 9050
Joined: Sat Jan 14, 2006 0:55
Location: Midwest USA

Postby sjeter » Sun Aug 12, 2007 22:17

Thanks, Wolfden, for your reply. Unfortunately, you're right - I had problems upgrading from 3.26 to 3.3 and ended up doing a fresh install.

Oh, well, this is my sandbox and I've learned a lot since 3.26 ...
sjeter
Simple Hen
 
Posts: 50
Joined: Wed Mar 07, 2007 14:09
Location: Near Houston, TX


Return to Installer Issues - Calamares **Not for Package Manager Stuff**

Who is online

Users browsing this forum: No registered users and 1 guest