WIFI Problemmes -- BROADCOM

Conversations générales au sujet de Sabayon Linux

Moderator: Moderators

WIFI Problemmes -- BROADCOM

Postby hanna » Sat Feb 24, 2007 11:08

Bonjour,

Je suis peu experimentée dans Linux et j'ai une problémme avec wifi. Mon portable c'est le Compaq Presario v6272 (mais je croie que c'est le mèmme que HP Pavilion dv6000).

Aussi, je ne parle pas trés bien le française, comme vous pouvez voir... :-P
J'ai lu qu'il y a quelques personnes avec ce mèmme problèmme, donc je vous indique ma configuration, parce que je suis trés desorientée:

----------------------------------------
#uname -r
2.6.19-gentoo-r4

#lspci

03:00.0 Network controller: Broadcom Corporation Dell Wireless 1390 WLAN Mini-PCI Card (rev 01)

#iwconfig

lo no wireless extensions.

eth0 no wireless extensions.

eth1 IEEE 802.11b/g ESSID:"" Nickname:"Broadcom 4311"
Mode:Managed Access Point: Invalid
RTS thr:off Fragment thr:off
Encryption key:off
Link Quality=0/100 Signal level=-256 dBm Noise level=-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

localhost sfreire # rmmod bcm43xx
localhost sfreire # ndiswrapper -i /home/sfreire/Desktop/bcmwl5a.inf
driver bcmwl5a is already installed

localhost sfreire # ndiswrapper -ma
module configuration information is stored in /etc/modules.d/ndiswrapper

localhost sfreire # modprobe ndiswrapper
localhost sfreire # dhclient eth1
Internet Systems Consortium DHCP Client V3.0.5rc2-Gentoo
Copyright 2004-2006 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/localhost sfreire # dhclient eth1
Internet Systems Consortium DHCP Client V3.0.5rc2-Gentoo
Copyright 2004-2006 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/

SIOCSIFADDR: No such device
eth1: unknown interface: No such device
eth1: unknown interface: No such device
Bind socket to interface: No such device

SIOCSIFADDR: No such device
eth1: unknown interface: No such device
eth1: unknown interface: No such device
Bind socket to interface: No such device
localhost sfreire # iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

localhost sfreire # dhclient eth1
Internet Systems Consortium DHCP Client V3.0.5rc2-Gentoo
Copyright 2004-2006 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/

SIOCSIFADDR: No such device
eth1: unknown interface: No such device
eth1: unknown interface: No such device
Bind socket to interface: No such device


#lsmod

bcm43xx 115988 0
ieee80211softmac 27008 1 bcm43xx
ieee80211 29384 2 bcm43xx,ieee80211softmac


#dmesg
[ 63.997395] bcm43xx: InitVals (bcm43xx_initvalXX.fw) file-format error. Please fix your bcm43xx firmware files.
[ 67.067308] fbsplash: console 1 using theme 'sabayon'
[ 67.078196] fbsplash: switched splash state to 'on' on console 1
[ 67.107871] fbsplash: console 2 using theme 'sabayon'
[ 67.116135] fbsplash: switched splash state to 'on' on console 2
[ 67.151158] fbsplash: console 3 using theme 'sabayon'
[ 67.175337] fbsplash: switched splash state to 'on' on console 3
[ 67.197467] fbsplash: console 4 using theme 'sabayon'
[ 67.209274] fbsplash: switched splash state to 'on' on console 4
[ 67.238260] fbsplash: console 5 using theme 'sabayon'
[ 67.302831] fbsplash: switched splash state to 'on' on console 5
[ 67.314134] fbsplash: console 11 using theme 'sabayon'
[ 67.326426] fbsplash: switched splash state to 'on' on console 11
[ 87.994847] bcm43xx: InitVals (bcm43xx_initvalXX.fw) file-format error. Please fix your bcm43xx firmware files.
[ 88.021906] eth0: no link during initialization.
[ 111.350573] bcm43xx: InitVals (bcm43xx_initvalXX.fw) file-format error. Please fix your bcm43xx firmware files.
[ 134.323379] bcm43xx: InitVals (bcm43xx_initvalXX.fw) file-format error. Please fix your bcm43xx firmware files.


localhost sfreire # lspci -vvn | grep -i 14e4
03:00.0 0280: 14e4:4311 (rev 01)

localhost sfreire # ifconfig
eth0 Link encap:Ethernet HWaddr 00:16:36:D7:BD:A9
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:20 Base address:0xe000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:39 errors:0 dropped:0 overruns:0 frame:0
TX packets:39 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3663 (3.5 Kb) TX bytes:3663 (3.5 Kb)

localhost sfreire # lspci | grep -i bcm
localhost sfreire #

------------------------------------------------------
voilá! si vous precisez d'autres donness, je vous-les aporterai...

Merci d'avance!!

Cordialemment,

Hanna
hanna
Young Hen
 
Posts: 32
Joined: Sun Feb 11, 2007 19:29

Wiki or search

Postby mdmarmer » Sat Feb 24, 2007 19:09

mdmarmer
Advanced Hen
 
Posts: 240
Joined: Thu Oct 19, 2006 1:46
Location: dayton OH usa

erreur avec emerge

Postby hanna » Sat Feb 24, 2007 20:10

Re-bonjour,

Je suis en train de faire ça qui dit dans
http://www.sabayonlinux.org/wiki/index. ... th_Sabayon
mais j'ai un erreur avec emerge:

localhost sfreire # lspci -n | grep 14e4:43
03:00.0 0280: 14e4:4311 (rev 01)
localhost sfreire # emerge gentoo-sources -pv

These are the packages that would be merged, in order:

Calculating dependencies... done!
[ebuild R ] sys-kernel/gentoo-sources-2.6.19-r4 USE="symlink -build" 0 kB [1]

Total size of downloads: 0 kB
Portage overlays:
[1] /usr/portage/local/layman/sabayon
localhost sfreire # emerge bcm43xx-fwcutter -pv

These are the packages that would be merged, in order:

Calculating dependencies... done!
[ebuild R ] net-wireless/bcm43xx-fwcutter-005 33 kB

Total size of downloads: 33 kB
localhost sfreire # emerge bcm43xx-fwcutter
Calculating dependencies... done!

>>> Emerging (1 of 1) net-wireless/bcm43xx-fwcutter-005 to /
>>> Downloading 'http://distfiles.gentoo.org/distfiles/bcm43xx-fwcutter-005.tar.bz2'
--20:02:57-- http://distfiles.gentoo.org/distfiles/b ... 05.tar.bz2
=> `/usr/portage/distfiles/bcm43xx-fwcutter-005.tar.bz2'
Resolviendo distfiles.gentoo.org... falló: Nombre o servicio desconocido.
>>> Downloading 'http://distro.ibiblio.org/pub/linux/distributions/gentoo/distfiles/bcm43xx-fwcutter-005.tar.bz2'
--20:02:58-- http://distro.ibiblio.org/pub/linux/dis ... 05.tar.bz2
=> `/usr/portage/distfiles/bcm43xx-fwcutter-005.tar.bz2'
Resolviendo distro.ibiblio.org... falló: Nombre o servicio desconocido.
>>> Downloading 'http://download.berlios.de/bcm43xx/bcm43xx-fwcutter-005.tar.bz2'
--20:02:58-- http://download.berlios.de/bcm43xx/bcm4 ... 05.tar.bz2
=> `/usr/portage/distfiles/bcm43xx-fwcutter-005.tar.bz2'
Resolviendo download.berlios.de... falló: Nombre o servicio desconocido.
!!! Couldn't download 'bcm43xx-fwcutter-005.tar.bz2'. Aborting.

Vous pouvez m'aider, svp??

Pour quoi ne fonctione pas emerge??

Merci beaucoup.
hanna
Young Hen
 
Posts: 32
Joined: Sun Feb 11, 2007 19:29

Postby malik » Sun Mar 18, 2007 23:53

Bonjour,

As-tu essayé cette methode, qui pour moi à fonctionné ,,,?

http://bastnic.info/index.php/post/2006 ... ilo-A1667G


@++
malik
Baby Hen
 
Posts: 10
Joined: Sun Mar 18, 2007 23:45


Return to French

Who is online

Users browsing this forum: No registered users and 1 guest

cron