Thx joost for reply. /etc/pulse/default.pa
There's a commented line about loading audio drivers statically then "load-module module-alsa-sink"
But this is followed by a line by [email protected]
: "Be sure to use line below. load-module module-hal-detect tschedule=0"
This is followed by:
"###Automatically load driver modules depending on hardware available
Then there's a line about static hardware detection module if udev support lacking.
Not sure what to do here. Assuming udev support is included. I use aureal vortex audio module for my sound card. PulseAudio works. Sound is working fine.