Two questions

If you are new to Linux or new to Sabayon Linux and just not sure where to post, here ya go. Post without fear of being told to RTFM :-)

Moderator: Moderators

Post Reply
Giosiken
Baby Hen
Posts: 1
Joined: Sun Oct 11, 2009 6:02

Two questions

Post by Giosiken » Sun Oct 11, 2009 6:25

Hi, i installed sabayon 5.0 recently, and made my first update through sulfur, and know i have two problems

1) im trying to install my HP Photosmart C3100, i've tried using the kde control center to install it but when i click on the printer config the control center says that the service "printer config" doesnt give the interface "KCMOdule" with the key word "system-config-printer-kde/system-config-printer-kde.py" The "factory" does not allow components...
That happens when the kde language is spanish, but when i changes to english everything works fine, theres somethin i can do to fix that?.

2) I have an msi K9 with nvdia chipset, and i have a quad sound system, but i cant configure correctly in kde, im too noob, could someone guide me?

thanks for all

genfool
Technological Hen
Posts: 344
Joined: Fri Apr 03, 2009 17:56
Location: Albuquerque, NM

Re: Two questions

Post by genfool » Sun Oct 11, 2009 14:36

for the sound issue, open a terminal and enter "alsamixer" use the arrow keys to navigate and turn everything up. usually my front speakers are turned down and is the problem.

If this does not cure it, in the terminal go root with "su" then enter root pass word and enter "alsaconfig" let it setup your sound card and then enter "exit" to become user and run alsamixer again.

good luck,

micia
Sagely Hen
Posts: 2718
Joined: Wed Nov 26, 2008 16:41
Contact:

Re: Two questions

Post by micia » Sun Oct 11, 2009 20:36

genfool wrote: and enter "alsaconfig" let it setup your sound card
There is a little typo, alsaconfig should be:

Code: Select all

alsaconf
We can save 2 characters! :D

Post Reply