Wireless Connection. Connected, but disconnect in seconds

Issues Related to Networking (Wired and Wireless)

Moderator: Moderators

Post Reply
User avatar
albfneto
Sagely Hen
Posts: 1912
Joined: Fri Nov 16, 2007 1:15
Location: Ribeirão Preto City, São Paulo State, Brazil
Contact:

Wireless Connection. Connected, but disconnect in seconds

Post by albfneto » Mon Jun 24, 2013 1:53

i have an wireless connection (bridge modem + wireless router with pppoe authentication).
in one of my sabayon installations (openRC+udev) all works, but

in my other Sabayon, after upgrading of systemd, in the boot, verbose mode, even using system d, OpenRC name appears, bit changed with the string "git", then, in the verbose lines,

many boot errors, following in the screen so fast to be viewed, but are mainly wlan0 errors and wpa_supplicant errors.

after, normal boot and the X, but connect the wireless is a pain! Usind wicd our networkmanager, the net "connect" but disconnect in seconds. after open a browser, it connect, but after 15-20 followed tries! As connection "on demand" but it is not on demand in the wireless router.
ALBERTO FEDERMAN NETO
albfneto
[email protected]
Favorite Distros: Sabayon, Gentoo, Mageia and OpenSUSE

Mattlxdesign
Baby Hen
Posts: 7
Joined: Sun May 05, 2013 13:38

Re: Wireless Connection. Connected, but disconnect in second

Post by Mattlxdesign » Mon Jun 24, 2013 6:24

I'm having the same problem, although i have not migrated over to systemd yet. I also get no errors showing up in the dmesg output. In fact my network connection shows full connection and for a while i do but then my connection drops out without showing. This happens randomly as far as i can tell and the only way i can get a dependable network connection is wired. This was never a problem previously.

sqlpython
Technological Hen
Posts: 386
Joined: Mon Jun 18, 2007 7:01
Location: If It Moves Compile It
Contact:

Re: Wireless Connection. Connected, but disconnect in second

Post by sqlpython » Mon Jun 24, 2013 17:19

I seem not to be having systemd wifi issues.
Here are my specs

Xfce Install

Code: Select all

 default/linux/x86/13.0/desktop
 3.7.0-sabayon #1 SMP Fri May 24 18:01:06 UTC 2013 i686 Intel
Using systemd
Updated packages 6/22/13
Using Network Manger Applet 0.9.6.4 (No Issues)

my net

Code: Select all

bobs-sl410 sqlpython # systemctl -a | grep net*
sys-devi...net-eth0.device loaded active   plugged   RTL8111/8168 PCI Express Gigabit Ethernet controller
sys-subs...ces-eth0.device loaded active   plugged   RTL8111/8168 PCI Express Gigabit Ethernet controller
sys-fs-f...nnections.mount loaded active   mounted   FUSE Control File System
sys-kernel-config.mount    loaded inactive dead      Configuration File System
sys-kernel-debug.mount     loaded active   mounted   Debug File System
systemd-...es-load.service loaded inactive dead      Load Kernel Modules
systemd-...ad-done.service loaded inactive dead      Stop Read-Ahead Data Collection
systemd-remount-fs.service loaded active   exited    Remount Root and Kernel File Systems
systemd-sysctl.service     loaded active   exited    Apply Kernel Variables
systemd-udevd.service      loaded active   running   udev Kernel Device Manager
systemd-...d-kernel.socket loaded active   running   udev Kernel Socket
network.target             loaded active   active    Network
systemd-...head-done.timer loaded inactive dead      Stop Read-Ahead Data Collection 10s After Completed Startup
ACTIVE = The high-level unit activation state, i.e. generalization of SUB.
Criticism accepted for Solutions that work. ;^)
Sabayon 13-DEBIAN 8- #! -Sid-Slackware 14-Calculate 13-Bridge

User avatar
albfneto
Sagely Hen
Posts: 1912
Joined: Fri Nov 16, 2007 1:15
Location: Ribeirão Preto City, São Paulo State, Brazil
Contact:

Re: Wireless Connection. Connected, but disconnect in second

Post by albfneto » Thu Jun 27, 2013 21:23

i partially resolved.
Using static IP, but using DHCP DNs, it works (with WICD)
Then i remain without net when i'm out of X.
Many wpa_sypplicant errors.
ALBERTO FEDERMAN NETO
albfneto
[email protected]
Favorite Distros: Sabayon, Gentoo, Mageia and OpenSUSE

Post Reply