Id just did a fresh install of the x64 version. All was sweet after I set the xorg.conf file to use vesa and not nv for the graphics.
Now the only problem I've come up against that's stumped me is I can't seem to get my eth0 network to function. Ive created manually via net-setup. I've create a "net" file from the sample incorporating:
Even set Static IP, static DHCP to MAC address on the router and tried it. No go.
The net.eth0 starts fine. ifconfig shows fine, but I can't for the life of me get out of the PC. My gateway is a router WRT54g and is hardwired and I get "destination unreachable" although it's directly connected. I searched for a firewall config and process and couldn't see one.
This has me well and truly stumped so any guidance would be much appreciated.