This is what happens when I try to go faster with gnomebaker:
- Code: Select all
cdrecord: No write mode specified.
cdrecord: Asuming -sao mode.
cdrecord: If your drive does not accept -sao, try -tao.
cdrecord: Future versions of cdrecord may have different drive dependent defaults.
scsibus: 2 target: 1 lun: 0
Linux sg driver version: 3.5.34
SCSI buffer size: 64512
Cdrecord-ProDVD-ProBD-Clone 2.01.01a32 (i686-pc-linux-gnu) Copyright (C) 1995-2007 JÃƒÂ¶rg Schilling
TOC Type: 0 = CD-DA
Using libscg version 'schily-0.9'.
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Vendor_info : 'MATSHITA'
Identifikation : 'UJ-840D '
Revision : '1.02'
Device seems to be: Generic mmc2 DVD-R/DVD-RW/DVD-RAM.
Profile: DVD-RW restricted overwrite
Profile: DVD-RW sequential recording
Profile: DVD-R sequential recording
Profile: CD-R (current)
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO
Drive buf size : 1310720 = 1280 KB
FIFO size : 4194304 = 4096 KB
Disk Is not erasable
Disk sub type: Medium Type B, low Beta category (B-) (4)
ATIP start of lead in: -12369 (97:17/06)
ATIP start of lead out: 359849 (79:59/74)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 69
Manufacturer: Moser Baer India Limited
Manufacturer is guessed because of the orange forum embargo.
The orange forum likes to get money for recent information.
The information for this media may not be correct.
Capacity Blklen/Sparesz. Type
4104234 2048 No Media Present or Unknown Capacity
Blocks total: 359849 Blocks current: 359849 Blocks remaining: 141987
Starting to write CD/DVD/BD at speed 24 in real SAO mode for single session.
Last chance to quit, starting real write in 5 seconds. 4 seconds. 3 seconds. 2 seconds. 1 seconds. 0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is ON.
Sending CUE sheet...
SAO startsec: -12369
Lead-in write time: 24.101s
Writing pregap for track 1 at -150
Starting new track at sector: 0
cdrecord: Input/output error. write_g1: scsi sendcmd: no error
CDB: 2A 00 00 00 42 57 00 00 1B 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: F1 00 03 00 00 3F DE 0A 00 2B 00 00 0C 00 00 00
Sense Key: 0x3 Medium Error, deferred error, Segment 0
Sense Code: 0x0C Qual 0x00 (write error) Fru 0x0
Sense flags: Blk 16350 (valid)
cmd finished after 5.056s timeout 200s
cdrecord: A write error occured.
cdrecord: Please properly read the error message above.
write track data: error after 39944016 bytes
Writing time: 62.683s
Average write speed 75.3x.
Min drive buffer fill was 97%
Fixating time: 0.001s
BURN-Free was never needed.
cdrecord: fifo had 693 puts and 630 gets.
cdrecord: fifo was 0 times empty and 629 times full, min fill was 98%.