I'm experiencing some trouble with writing CD's in Sabayon and I think it has something to do with cdrdao or something. the weird thing is, I have this problem on both my laptop and my desktop PC...
and on both I can write DVD's without any problems or error messages, but I can't write CD's on both.
everytime I try to write a CD it starts and looks like its burning well, but at 5 or 7% he stops and gives an input/output buffer underrun error or something...
this is the output I get from K3B:
- Code: Select all
System
-----------------------
K3b Version: 0.12.17
KDE Version: 3.5.6
QT Version: 3.3.6
Kernel: 2.6.20-sabayon-r3
Devices
-----------------------
HL-DT-ST DVDRAM GMA-4084N KR01 (/dev/sr0, /dev/sg1) at [CD-R; CD-RW; CD-ROM; DVD-ROM; DVD-RAM; DVD-R; DVD-RW; DVD-R DL; DVD+R; DVD+RW; DVD+R DL] [DVD-ROM; DVD-R sequentieel; DVD-R Dual Layer sequentieel; DVD-R Dual Layer Jump; DVD-RAM; DVD-RW met beperkte overschrijving; DVD-RW sequentieel; DVD+RW; DVD+R; DVD+R Double Layer; CD-ROM; CD-R; CD-RW] [SAO; TAO; RAW; SAO/R96P; SAO/R96R; RAW/R16; RAW/R96P; RAW/R96R; Beperkt overschrijven; Layer Jump]
K3b
-----------------------
Size of filesystem calculated: 28426
Used versions
-----------------------
cdrecord: 2.1.1a20
cdrecord
-----------------------
scsidev: '3,0,0'
scsibus: 3 target: 0 lun: 0
Linux sg driver version: 3.5.34
SCSI buffer size: 64512
Cdrecord-ProDVD-Clone 2.01.01a20 (x86_64-unknown-linux-gnu) Copyright (C) 1995-2006 Jörg Schilling
TOC Type: 3 = CD-ROM XA mode 2
Using libscg version 'schily-0.8'.
Driveropts: 'burnfree'
atapi: 1
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Capabilities :
Vendor_info : 'HL-DT-ST'
Identifikation : 'DVDRAM GMA-4084N'
Revision : 'KR01'
Device seems to be: Generic mmc2 DVD-R/DVD-RW/DVD-RAM.
Current: CD-R
Profile: DVD-RAM
Profile: DVD-R sequential recording
Profile: DVD-R/DL sequential recording
Profile: DVD-R/DL layer jump recording
Profile: DVD-RW sequential overwrite
Profile: DVD-RW restricted overwrite
Profile: DVD+RW
Profile: DVD+R
Profile: DVD+R/DL
Profile: DVD-ROM
Profile: CD-R (current)
Profile: CD-RW
Profile: CD-ROM
Profile: Removable Disk
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R LAYER_JUMP
Drive buf size : 1053696 = 1029 KB
Drive pbuf size: 1966080 = 1920 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 55 MB
Total size: 63 MB (06:19.04) = 28428 sectors
Lout start: 64 MB (06:21/03) = 28428 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 4
Is not unrestricted
Is not erasable
Disk sub type: Medium Type A, low Beta category (A-) (2)
ATIP start of lead in: -12508 (97:15/17)
ATIP start of lead out: 359845 (79:59/70)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 22
Manufacturer: Ritek Co.
Capacity Blklen/Sparesz. Type
0 2048 No Media Present or Unknown Capacity
Blocks total: 359845 Blocks current: 359845 Blocks remaining: 331417
Starting to write CD/DVD at speed 16 in real TAO mode for multi session.
Last chance to quit, starting real write in 3 seconds.
2 seconds.
1 seconds.
0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is OFF.
Turning BURN-Free on
Performing OPC...
Starting new track at sector: 0
Track 01: 0 of 55 MB written.
Track 01: 1 of 55 MB written (fifo 100%) [buf 99%] 0.6x.
Track 01: 2 of 55 MB written (fifo 100%) [buf 99%] 10.4x.
Track 01: 3 of 55 MB written (fifo 100%) [buf 99%] 10.8x.
Track 01: 4 of 55 MB written (fifo 100%) [buf 99%] 10.5x.
/usr/bin/cdrecord: Input/output error. write_g1: scsi sendcmd: no error
CDB: 2A 00 00 00 08 D7 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 10 2A 30 02 80 21 02 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x21 Qual 0x02 (invalid address for write) Fru 0x0
Sense flags: Blk 0 (not valid)
resid: 63488
cmd finished after 0.002s timeout 40s
/usr/bin/cdrecord: The current problem looks like a buffer underrun.
/usr/bin/cdrecord: It looks like 'driveropts=burnfree' does not work for this drive.
/usr/bin/cdrecord: Please report.
/usr/bin/cdrecord: Make sure that you are root, enable DMA and check your HW/OS set up.
write track data: error after 4634624 bytes
Writing time: 21.059s
Average write speed 18.0x.
Min drive buffer fill was 99%
Fixating...
Fixating time: 28.609s
/usr/bin/cdrecord: fifo had 137 puts and 74 gets.
/usr/bin/cdrecord: fifo was 0 times empty and 63 times full, min fill was 92%.
cdrecord command:
-----------------------
/usr/bin/cdrecord -v gracetime=2 dev=3,0,0 speed=18 -tao driveropts=burnfree -eject -multi -xa -tsize=28426s -
mkisofs
-----------------------
28426
1.76% done, estimate finish Fri May 25 16:03:43 2007
3.56% done, estimate finish Fri May 25 16:03:43 2007
5.31% done, estimate finish Fri May 25 16:03:43 2007
7.05% done, estimate finish Fri May 25 16:03:43 2007
8.80% done, estimate finish Fri May 25 16:06:22 2007
10.60% done, estimate finish Fri May 25 16:06:04 2007
12.34% done, estimate finish Fri May 25 16:05:52 2007
14.09% done, estimate finish Fri May 25 16:05:36 2007
/usr/bin/mkisofs: Connection reset by peer. cannot fwrite 32768*1
mkisofs command:
-----------------------
/usr/bin/mkisofs -gui -graft-points -volid Gary-drivers -volset -appid K3B THE CD KREATOR (C) 1998-2005 SEBASTIAN TRUEG AND THE K3B TEAM -publisher -preparer -sysid LINUX -volset-size 1 -volset-seqno 1 -sort /tmp/kde-dyingmuppet/k3bsXCdBa.tmp -rational-rock -hide-list /tmp/kde-dyingmuppet/k3ba8R0Va.tmp -joliet -hide-joliet-list /tmp/kde-dyingmuppet/k3bU1tnfb.tmp -full-iso9660-filenames -iso-level 2 -path-list /tmp/kde-dyingmuppet/k3bASzLga.tmp
I also tried to uncheck the BurnFree option but that wouldn't help...
This problem also exist in all other cd-burning programs, so I think it has something to do with cdrdao, but I'm not familiar with this so I need some help here...
thnx DM
