That's the sort of solution I had hoped for, but i get this output:
- Code: Select all
Calculating dependencies... done!
emerge: there are no ebuilds to satisfy "ralink-rt2860-firmware".
emerge: searching for similar names...
emerge: Maybe you meant any of these: net-wireless/rt61-firmware, sys-kernel/linux-firmware, net-wireless/libertas-firmware?
Do I need to add a different overlay or something?
One thing that might matter is that when I try to update portage I get
- Code: Select all
Calculating dependencies... done!
[ebuild U *] sys-apps/portage-2.2.0_alpha51 [2.2.0_alpha37] USE="less%*"
*** Portage will stop merging at this point and reload itself,
then resume the merge.
[blocks B ] <app-admin/logrotate-3.8.0 ("<app-admin/logrotate-3.8.0" is blocking sys-apps/portage-2.2.0_alpha51)
* Error: The above package list contains packages which cannot be
* installed at the same time on the same system.
(sys-apps/portage-2.2.0_alpha51::gentoo, ebuild scheduled for merge) pulled in by
portage
For more information about Blocked Packages, please refer to the following
section of the Gentoo Linux x86 Handbook (architecture is irrelevant):
http://www.gentoo.org/doc/en/handbook/handbook-x86.xml?full=1#blocked
!!! The following installed packages are masked:
- net-wireless/broadcom-sta-5.100.82.38-r1::gentoo (masked by: Broadcom license(s))
A copy of the 'Broadcom' license is located at '/usr/portage/licenses/Broadcom'.
For more information, see the MASKED PACKAGES section in the emerge
man page or refer to the Gentoo Handbook.
Sorry, I'm not very good at portage...