Anyway full log from smartctl 6.0.
- Code: Select all
smartctl 6.0 2012-10-10 r3643 [i686-linux-3.5.6-pmagic] (local build)
Copyright (C) 2002-12, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Barracuda ES
Device Model: ST3250620NS
Serial Number: ********
Firmware Version: 3.AEG
User Capacity: 250,059,350,016 bytes [250 GB]
Sector Size: 512 bytes logical/physical
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA/ATAPI-7 (minor revision not indicated)
Local Time is: Sat Oct 13 18:31:29 2012 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 430) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 92) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 118 088 006 Pre-fail Always - 195261538
3 Spin_Up_Time 0x0003 096 095 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 098 098 020 Old_age Always - 2060
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 085 060 030 Pre-fail Always - 344831142
9 Power_On_Hours 0x0032 079 079 000 Old_age Always - 18659
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 098 098 020 Old_age Always - 2447
187 Reported_Uncorrect 0x0032 064 064 000 Old_age Always - 36
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 064 053 045 Old_age Always - 36 (Min/Max 36/36)
194 Temperature_Celsius 0x0022 036 047 000 Old_age Always - 36 (0 12 0 0 0)
195 Hardware_ECC_Recovered 0x001a 072 054 000 Old_age Always - 20816722
197 Current_Pending_Sector 0x0012 001 001 000 Old_age Always - 4294967293
198 Offline_Uncorrectable 0x0010 001 001 000 Old_age Offline - 4294967293
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
200 Multi_Zone_Error_Rate 0x0000 100 253 000 Old_age Offline - 0
202 Data_Address_Mark_Errs 0x0032 228 125 000 Old_age Always - 128
SMART Error Log Version: 1
ATA Error Count: 36 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 36 occurred at disk power-on lifetime: 17787 hours (741 days + 3 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 01 2b ab 3c e0 Error: UNC at LBA = 0x003cab2b = 3975979
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 00 d5 a6 3c e0 00 00:20:15.316 READ VERIFY SECTOR(S) EXT
42 00 00 d5 9e 3c e0 00 00:20:15.300 READ VERIFY SECTOR(S) EXT
42 00 00 d5 96 3c e0 00 00:20:15.279 READ VERIFY SECTOR(S) EXT
42 00 00 d5 8e 3c e0 00 00:20:15.262 READ VERIFY SECTOR(S) EXT
42 00 00 d5 86 3c e0 00 00:20:15.242 READ VERIFY SECTOR(S) EXT
Error 35 occurred at disk power-on lifetime: 17787 hours (741 days + 3 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 01 d4 6e ff e0 Error: UNC at LBA = 0x00ff6ed4 = 16740052
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 00 eb 6b ff e0 00 00:19:36.971 READ VERIFY SECTOR(S) EXT
42 00 00 eb 63 ff e0 00 00:19:36.952 READ VERIFY SECTOR(S) EXT
42 00 00 eb 5b ff e0 00 00:19:36.935 READ VERIFY SECTOR(S) EXT
42 00 00 eb 53 ff e0 00 00:19:36.915 READ VERIFY SECTOR(S) EXT
42 00 00 eb 4b ff e0 00 00:19:36.898 READ VERIFY SECTOR(S) EXT
Error 34 occurred at disk power-on lifetime: 17787 hours (741 days + 3 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 01 ea 1b d9 e0 Error: UNC at LBA = 0x00d91bea = 14228458
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 00 e4 1a d9 e0 00 08:52:55.416 READ VERIFY SECTOR(S) EXT
42 00 00 e4 12 d9 e0 00 08:52:55.403 READ VERIFY SECTOR(S) EXT
42 00 00 e4 0a d9 e0 00 08:52:55.389 READ VERIFY SECTOR(S) EXT
42 00 00 e4 02 d9 e0 00 08:52:55.379 READ VERIFY SECTOR(S) EXT
42 00 00 e4 fa d8 e0 00 08:52:55.364 READ VERIFY SECTOR(S) EXT
Error 33 occurred at disk power-on lifetime: 17787 hours (741 days + 3 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 01 e3 52 d8 e0 Error: UNC at LBA = 0x00d852e3 = 14176995
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 00 6a 51 d8 e0 00 08:52:53.331 READ VERIFY SECTOR(S) EXT
42 00 00 6a 49 d8 e0 00 08:52:53.320 READ VERIFY SECTOR(S) EXT
42 00 00 6a 41 d8 e0 00 08:52:53.305 READ VERIFY SECTOR(S) EXT
42 00 00 6a 39 d8 e0 00 08:52:53.294 READ VERIFY SECTOR(S) EXT
42 00 00 6a 31 d8 e0 00 08:52:53.280 READ VERIFY SECTOR(S) EXT
Error 32 occurred at disk power-on lifetime: 17786 hours (741 days + 2 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 01 69 b9 5e e0 Error: UNC at LBA = 0x005eb969 = 6207849
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 00 ad b2 5e e0 00 08:43:14.102 READ VERIFY SECTOR(S) EXT
42 00 00 00 b0 5e e0 00 08:43:14.089 READ VERIFY SECTOR(S) EXT
42 00 00 00 a8 5e e0 00 08:43:14.076 READ VERIFY SECTOR(S) EXT
42 00 00 00 a0 5e e0 00 08:43:14.064 READ VERIFY SECTOR(S) EXT
42 00 00 00 98 5e e0 00 08:43:14.050 READ VERIFY SECTOR(S) EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Extended offline Completed without error 00% 18656 -
# 2 Short offline Completed without error 00% 18645 -
# 3 Short offline Completed without error 00% 18601 -
# 4 Short offline Completed without error 00% 18456 -
# 5 Extended offline Aborted by host 70% 18455 -
# 6 Short offline Completed without error 00% 17811 -
# 7 Short offline Completed without error 00% 17811 -
# 8 Short offline Interrupted (host reset) 90% 17810 -
# 9 Short offline Completed without error 00% 17809 -
#10 Short offline Completed without error 00% 17808 -
#11 Short offline Completed without error 00% 17792 -
#12 Short offline Completed without error 00% 17791 -
#13 Short offline Completed without error 00% 17790 -
#14 Short offline Completed without error 00% 17787 -
#15 Short offline Completed without error 00% 17787 -
#16 Short offline Completed: read failure 90% 17786 406629163
#17 Short offline Completed without error 00% 17670 -
#18 Short offline Completed without error 00% 13881 -
#19 Short offline Completed without error 00% 13423 -
#20 Short offline Completed without error 00% 13420 -
#21 Short offline Aborted by host 50% 13420 -
1 of 1 failed self-tests are outdated by newer successful extended offline self-test # 1
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.