Sabayon installation on USB Disk (USB-3.0)

[Speedy1205]

Hey Guys,

I installed the Sabayon on my USB Disk which i connected to the USB 3.0 and the installation worked fine. When I reboot now the machine and boot from the USB disk (USB 3.0 port) in can not find the root partition.

When I switch to the USB 2.0 Port, than it is working fine. Are there some Modules which I have have to load manually ?

Anyone know what I have to change, that I can boot it on an USB 3.0 Port ?

Thanks a lot !

Best regards

[Speedy1205]

no ideas on this ? I really would like to have it on the USB 3.0 as it is much faster.