Kwin Crash

[sqlpython]

Not big News but I reported the Bug...
Message was Generic .. Executable: kwin PID: 7472 Signal: Segmentation fault (11)

The situation was the Desktop was booted to on Start up.
No apps no Windows open..
This is the Default Sabayon 5.5 installed Desktop Same wallpaper etc etc..
The Only change from default was that a Screen Saver with 10 min delay is active and it had activited..
It sat there with no activity for 20 minutes as I used another computer..
I received the Crash report but it had apparently recovered on it's own..

[sqlpython]

Hmmm... happened again..
I will try to run 1st without ScreenSaver and then if necessary w/o SPecial effects turned On.


Some specs..
IBM Thinkpad sl410 with centrino processor..
Graphics
00:00.0 Host bridge: Intel Corporation Mobile 4 Series Chipset Memory Controller Hub (rev 07)
00:02.0 VGA compatible controller: Intel Corporation Mobile 4 Series Chipset Integrated Graphics Controller (rev 07)
00:02.1 Display controller: Intel Corporation Mobile 4 Series Chipset Integrated Graphics Controller (rev 07)
mem
total used free shared buffers cached
Mem: 2942044 977372 1964672 0 90196 402716
-/+ buffers/cache: 484460 2457584
Swap: 9107452 0 9107452

[sqlpython]

Ok it ran all day about 8 hrs on my desk without a Kscreensaver and No Problems at all..
I right clicked the Desktop and Locked it..
The screensaver started. About 1 min later I hit the touchpad started to enter the Password.. and Complete BlackScreen lockup with my Mouse cursor floating around..
Waited...Waited...Waited... 5 min no luck..
The only way to shut this puppy down was the Power Button..
Rebooted to Sabayon..Firefox restarted and remembered the pages...natch..
So the BUG appears to crash Kwin with Kscreensaver.
Kscreensaver has always been reliable but not with KDE 4.6 at this time..