Sabayon Community

by **MAGNET** » Sun Oct 15, 2006 22:00

Lxnay, could you please compile Sabayon with twinview or something similar, xinerama, USE flags? i had no problem with 3.0 but in 3.1 i have popups displaying on the middle of the screen.. the software starts ok on one screen and fullsize also is on 1 screen but when i get popups from those softwares it always display on the center.. i dont know why i didn't had a problem with 3.0 though..

cheers

by **cvill64** » Sun Oct 15, 2006 22:02

certain programs just do that for some reason. It does have the xinerama use flags, check make.conf

by **MAGNET** » Sun Oct 15, 2006 22:03

Control panel wasn't doing this on 3.0

by **lxnay** » Sun Oct 15, 2006 22:33

XINERAMA support is enabled system-wide.

by **MAGNET** » Sun Oct 15, 2006 22:59

that confirms what cvill64 wrote above.

i guess i need to emerge the world then..

by **cooldude** » Tue Oct 17, 2006 15:28

i get the same problem no matter which distro i am using , it happens with openoffice.

after the program starts, it goes to its respective screen.

I think it is a problem with programs that are not twinview aware .

cheers

Al'

Sabayon Community

Compiling with twinview

Compiling with twinview

twinview

Who is online